• Registered: 2008-06-21
  • Posts: 22

Topic: 3.099 Driver and Totalmix wierd behaviour.... FF400

There is some strange behavior when adjusting values of levels using the knob on the FF400....

I have 3x stereo pairs of outputs (AN1-6) grouped. If use the knob on the FF400, set at L.1 to control the level of the fader, when I move to the left it adjusts the pan of AN1/2 and when I move to the right it adjusts the fader levels up and pans to the left at the same time....

  • From: Germany
  • Registered: 2007-04-10
  • Posts: 9,565

Re: 3.099 Driver and Totalmix wierd behaviour.... FF400

Press and hold the encoder (while showing a channel name) for a few seconds until it shows "ON" (stereo mode).

Regards
Daniel Fuchs
RME

Regards
Daniel Fuchs
RME

RME Support's Website

3 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 24,912

Re: 3.099 Driver and Totalmix wierd behaviour.... FF400

Fully logical. Set the unit's encoder to stereo mode by pushing it for 2 seconds.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2008-06-21
  • Posts: 22

Re: 3.099 Driver and Totalmix wierd behaviour.... FF400

yep thanks that works..... thanks for super prompt response.....